Curtis 2000 Spécifications télécharger pdf (Page 27)

Curtis PMC 1223/33, 1225/35, 1227/37 Manual

Curtis ET-XXX Electronic Throttle

The recommended wiring for the Curtis ET-XXX electronic throttle is shown in

Figure 12. The ET-XXX throttle provides a single-ended 0–5V throttle signal and

a signal indicating whether it is in forward or reverse. If the controller is

conﬁgured to require only a single direction switch, only the reverse output wire

(white wire) needs to be connected. If the controller is conﬁgured to require

separate inputs for forward and reverse, the forward output wire (black/white

wire) must also be connected. NOTE: The controller must be programmed as a

single-ended 0–5V throttle type for use with the ET-XXX.

As with any 0–5V throttle, there is no fault detection built into the ET-XXX.

It is the responsibility of the vehicle manufacturer to provide throttle fault

detection when using the ET-XXX.

2 — INSTALLATION & WIRING:

Throttle

Fig. 12 Wiring for Curtis

ET-XXX electronic throttle.

GREEN

ORANGE

BLACK

BLACK/WHITE

WHITE

WHT/BRN

B+

KEYSWITCH

B-

Pin 15

Pin 13

Pin 12

Pin 2

KSI Input

Direction/Reverse

Forward

0–5V Input

PIN KEY

B-

WHT/

GRN

connector

only for controllers that require separate inputs

for forward and reverse (Direction Input Type “2”)

16 15 14 13 12 11 10 9

87654321

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 92 93

Pas de commentaire

Curtis 2000 Spécifications Page 27