Curtis LCDVD2440A Manuel d'utilisateur télécharger pdf (Page 15)

WALL MOUNT INSTALLATION

INSTALLING REMOVING THE BASE STAND

WARNING

: The TV Display is very fragile and must be protected at a ll times when removing t he base

Stand

Be sure that no hard or sharp object or anything that could scratch or damage the TV display comes into

contact with it Do NOT exert pressure on the front of the unit at any time because the screen could crack

1 Disconnect all cables or cords connected to the unit

2 Lay the unit down on a flat surface with the back side facing up Please make sure to place a soft

cushioned material such as a pillow or thick piece of foam beneath the screen

3 To remove the base stand loosen screws off the holes then pull downwards to release

the base stand

4 To install the base stand put the stand into the hole at the bottom of the TV then insert screws to the

holes and tighten.

. .

. ,

MOUNTING ON THE WALL

NOTE

Remove the base stand before mounting the unit on the wall.

This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 4”x 4 ”

(100mm x 100mm) mounting kit designed for flat-panel TV's (not supplied). Mount this unit according to

the instructions included in the mounting kit.

Length of screw should not exceed 8 mm.

4”

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 44 45

Pas de commentaire

Curtis LCDVD2440A Manuel d'utilisateur Page 15