36 | Page
Copyright © 2009 Curtis Dyna-Fog, LTD.
CHECK ON-OFF CONTROL ADJUSTMENT
The On-Off Control linkage should rotate the linkage stop from fully open to fully
closed position.
Figure 7
AFTER EVERY 25 HOURS OF OPERATION
CLEAN THE FORMULATION INJECTION ORIFICE
1. Disconnect the Formulation Injection Line at the injection end and then
remove the elbow assembly (Fig. 7)
2. Insert a wire through the Coupling into the engine tube to remove carbon
deposits
3. Reassemble the Elbow and the Formulation Injection Line. Apply a pipe
sealant to the pipe threads of the nipple prior to the assembly.
CHECK THE FUEL FILTER
Inspect the Fuel Filter (Fig. 3) in the fuel line. If it is dirty, replace the filter for a
new one (P/N-58316). Inspect the filter located within the carburetor (see Figure
13 for location).
Commentaires sur ces manuels